EngadgetMost models can be printed with 10 to 15 percent infill, according to Prusa, and Flashforge recommends 20 percent as a starting point for general use.
Science
What is infill in 3D printing and is it necessary?
Summarized version
Most models can be printed with 10 to 15 percent infill, according to Prusa, and Flashforge recommends 20 percent as a starting point for general use.
The report’s most important sentence, shortened and in plain words. How
From the report
Headline check
There is nothing in this headline a machine can check against the report: no figure, no name and no quotation.
Nothing was measured here, so nothing is claimed. How this is checked
This is a summary. The indicators are not. Every score on this page was measured over the full 664-word report, which is the only way the numbers mean anything.
How this outlet filed it, and how we rewrote it
No other newsroom we read has filed on this event, so there is nothing to compare it with yet.
| Outlet | Niral Score |
|---|---|
| Engadgetas they published this story | 17.6 |
How did this read?
Sign in to react.
Comments
Comments are not open yet. They will be once there is someone to read every one before it appears. If something here is wrong, tell us — that we do read.
Report a problem with these scores or this rewrite — it goes straight into the public ledger.